分分快三在线人工计划

News and information
Corporate news
How to install industrial plug and socket?
Source: Taixi electric Date: February 22, 2019

Plug and socket must be correctly installed and used to avoid all kinds of errors and problems, which must be given enough attention.

1、 Installation of sockets and appliance input sockets

1. General requirements

The installation of the socket is basically the same as that of the appliance input socket. As long as it is concealed or surface mounted, connect the socket according to the requirements, and then fix it with screws, as shown in Fig

The concealed installation method is to insert it into the panel with a good installation hole and fix it with screws. It is usually used for box or electric screen. The wiring terminals are in the panel and are not exposed.

The open installation method is to fix the rear seat directly on the wall or equipment, and the wire can be connected to the back seat through the open wire or through the wall. As long as the back cover is opened, the wiring terminal can be seen and sealed with the cable.

The connector is installed in the same way as the plug.

2. Connect the cable

The flexible cable conforming to GB 5013.4-1997 must be used for the connection of plug or connector. See table for selection of cross section area of cable copper conductor

2、 Installation of plug and connector

1. General requirements

The plug and connector are lifted by hand, and the connection must be installed with flexible cable.

For the installation of common plug, first remove the shell, insert the tail cable sleeve into the cable by hand, confirm the phase sequence wiring, and tighten the terminal screw. Then clamp the cable with the cable rack, and the cable sheath should grow about 5 ~ 10 mm. See Figure:

Then lock the clip to prevent the cable from being pulled out. Finally, replace the shell and fix it with screws.

The tail of anti immersion plug is rubber washer and threaded gland, so the gland should be tightened to seal with cable.

2. Connect the cable

The connection of plug or connector must conform to the flexible cable of GB 5013.4-1997. See table for selection of cross section area of cable copper conductor

The connector is installed in the same way as the plug.

3、 Installation of quick plug and socket

There are various forms of quick plug and socket. Please refer to the manufacturer's product manual or manual for installation and wiring.